Setting Frost Protection (Off); Configuration Menu (Menu) (Operation Without The Cube) - eQ-3 EasyHome control Bedienungsanleitung

16. Setting frost protection (OFF)

If the room does not need to be heated, the valve can be
closed. The valve is only opened if there is a risk of frost.
The calcification protection function continues to run. To
activate this, proceed as follows:
• In manual operation (Manu) press the (-) button until
"OFF" is shown on the display.
• To finish, exit manual operation (Manu) or press the (+)
button until the desired temperature is set.
If you operate your system with a Cube, you can
conveniently set the functions described in the
following chapters in the software in each room.
The following steps explain how these functions
are set when operating without Cube. In combi-
nation with the Cube these functions are deacti-
vated at the wall thermostat.
If you operate the wall thermostat without the
cube, you can not do any settings from afar via
the software.
Settings can be changed in the Configuration menu when
using without Cube. The menu can be accessed by pres-
sing the Mode button for more than 3 seconds.
The menu items are selected with the (+) and (-) button and
confirmed with the OK button. A subsequent pressing of the
17. Configuration menu (Menu)
(Operation without the Cube)
41