eQ-3 EasyHome control Bedienungsanleitung Seite 47

• Once the Boost time has completed the wall thermos-
tat will switch back to the previously active mode (Auto/
Manu) and the previously set temperature.
• The Boost function can be deactivated at any time by a
renewed press of the OK button.
The length and valve opening of the Boost function can be
individually adjusted as follows:
• Press the Menu button for more than 3 seconds.
• Select the "bOS" menu item with the (+) and (-) buttons.
• Confirm the setting with the OK button.
• Use the (+) and (-) buttons to set the duration of the Boost
from 0 to 30 minutes (0, 5, 10, 15, 20, 25, 30 mins.). Choo-
sing 0 will deactivate this function.
• Confirm the setting with the OK button.
• Subsequently set the valve opening between 0 and 100%
in 5% increments with the (+) and (-) buttons. The larger
the valve opening, the higher will be the heat emitted
by the radiator.
• Confirm the setting with the OK button.
If a long "Boost period" and a large valve opening
have been set the radiator can get very hot. After
changing the factory setting check that the radiator
is not heated excessively.
The radiant heat will have no immediate effect if the
radiator is covered up (e.g. by a settee).
If the duration of the "Boost function" is set so that
999 seconds are exceeded (e.g. via the Cube) the
display will show the duration in minutes.
47