EN
15.5
Start-up and run-down parameters
The set start-up and run-down parameters are displayed.
x: 1-9 = start-up stage, t = start-up time
y: 1-9, 1b-9b = braking stage, 0 = unbraked run-down, t = run-down time
y
x
15.5.1
Start-up stage and start-up time
It is only possible to set start-up times if these have been activated. See the chapter "Activating or deactivating
start-up and run-down times".
Press the
key until the parameter
= start-up stage,
t
= start-up time
Press the
key to switch between the start-up stage and start-up time.
TIME
Set the desired stage or time with the rotary knob .
If necessary, press the
To apply the setting to the display, either press the
the centrifugation data are displayed.
15.5.2
Braking stage and run-down time
B-brake stages can only be set for rotors which are suitable for the use of blood bags.
The B-braking stages can only be set if this is activated. See chapter "Activate or deactivate B-braking
stages".
It is only possible to set run-down times if these have been activated. See the chapter "Activating or
deactivating start-up and run-down times".
Press the
key until the parameter
= braking stage,
= B- braking stage,
Press the
key to switch between the braking stage and run-down time.
TIME
The B-braking stages are displayed after braking stage 9.
Set the desired stage or time with the rotary knob .
The B-braking stages are displayed after braking stage 9.
If necessary, press the
To apply the setting to the display, either press the
the centrifugation data are displayed.
15.5.3
Brake switch-off speed
Press the
key as often as necessary until the parameter N Brake is shown.
Use the adjusting knob
Press the
or
START
66/203
or
is displayed.
t
key to set the next parameter.
START
or
or
t
t
= run-down time
key to set the next parameter.
START
to set the value you want.
keys to apply the setting to the display.
key or press the
key as often as is required until
is displayed.
key or press the
key as often as is required until