Pin (Personal Identification Number); Setting Or Changing The Pin; Procedure In The Event That Pin Is Lost - Hettich ROTANTA 460 Bedienungsanleitung

29

PIN (Personal Identification Number)

To prevent the program lock from being changed by unauthorized persons, a PIN can be set.
No PIN is set in the factory.
29.1

Setting or changing the PIN

The PIN can be set as follows when the rotor is at a standstill:
The operation can be cancelled at any time by pressing the
stored.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Change PIN is displayed.
PROG

Press the key. old PIN = ---- <START> is displayed.
START

With the adjusting knob, set the valid PIN.
If the PIN is being set for the first time, then skip this step or set "0000".
Input assistance:
Press and hold the respective button.
: Only the 1000s place of the PIN will be changed.
: Only the 100s place of the PIN will be changed.
RCF
: Only the 10s place of the PIN will be changed.
RPM

Press the key. new PIN = ---- <START> is displayed.
START
If an incorrect PIN is set, then old PIN = ---- <START> will be displayed again. In this case, set the
valid PIN with the

With the adjusting knob, set the new PIN.
To deactivate the PIN, "0000" has to be set.

Press the key to save the setting.
START
Briefly, Store PIN ... is displayed as confirmation, followed by -> Change PIN.

Press the key once to leave the "Change PIN" menu or press the
OPEN / STOP
the "Machine Menu".
29.2

Procedure in the event that PIN is lost

If the PIN has been lost, a so-called Help number can be requested. With the help of this number, the manufacturer
can calculate a PIN to replace the previously valid PIN. In case this is required, please contact your supplier.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Change PIN is displayed.
PROG

Press the key. old PIN = ---- <START> is displayed.
START

Press the key. Get HELP # no is displayed.
PROG
After querying the Help number, the previous PIN becomes invalid.

Set yes with the adjusting knob.

Press the key. Are you sure ? no is displayed
START

Set yes with the adjusting knob.

Press the key. A help number is displayed, e.g. HELP # = 5487.
START

Note this help number and use it to request the needed PIN.

Set a new PIN with the PIN you receive (see the chapter on "Setting or changing the PIN").
adjusting knob and then press the
key. In this case, the settings are not
OPEN / STOP
button.
START
key twice to leave
OPEN / STOP
EN
77/203