Faults With Display; Faults Without Display - Kärcher SB-Wash-E 10 Bedienungsanleitung

Fault Possible cause
Indicator lamp Container for the softener is empty
Softener liquid
blinks
Display Cause
E001 Set off the motor protection switch
high pressure pump
Winding protection contact motor
E002 Fuse - F1 has triggered, circulat-
ing pump, heat fan
E003 Motor protection switch of the
heater has triggered
Temperature limiter 90°C trig-
gered
E100 Interruption control circuit
Fault Possible cause
Plant is not run- Mains fuse have got triggered
ning
No pressure Amount of water supply is too low.
build-up in the
Heating coil has heavy calcium deposits
plant or pump is
knocking
Pipe is blocked
System is sucking air
No reduced pres- Wrong adjustment in the function menue
sure when using
program 2 and 4
Pump leaky Defective pump part
(more than 3
drops of water
per minute)
Detergent is not Filter or hose is blocked
taken in
Magnet valve or check valve defect
Pump hose of the dosing pump damaged. Check the pump hose for cracks and wear; replace if
high pressure Detergent container is empty
pump does draw
air
Too low water Temperature has been set too low.
temperature for
Nozzle in spray pipe is rinsed out.
hot water opera-
tions
Interruption with a display of the operating panel

Faults with display

Remedy
Reset motor protection switch; call Customer Service if the
problem recurs.
Allow engine to cool down and call Customer Service if this
occurs again.
Switch on the fuse again, call Customer Service if this occurs
again.
Reset motor protection switch; call Customer Service if the
problem recurs.
Reset temperature limiter.
Turn off the equipment, wait, turn on the equipment.

Faults without display

Remedy
Check mains fuses and mains voltage
Check water supply level (refer to technical data).
base exchanger (optional) or water softener with RM
110 (optional) does not work. Rectify cause, decalcify
the plant.
Check all pipes to see that there are no blockages
Check system for leaks, the detergent suction hoses
must lie in the detergent, refill detergent container.
Check the pump hose for cracks and wear; replace if
required.
Set the "Half-load" function in the function menu to
"On".
Replace defective part.
Clean the parts.
Replace valve.
required.
Refill detergent.
Set the thermostat to a higher level.
Define the quantity to be transported by the pump.
Replace nozzle if the specifications given in the tech-
nical data are exceeded with a large margin.
EN
Remedy
Refill container for the softener.
12
-
By whom
Operator
By whom
Operator
Operator
Operator
Operator
Operator
Operator
By whom
Operator
Operator
Operator,
Customer
Service
Operator
Operator
Operator,
Customer
Service
Operator,
Customer
Service
Customer
Service
Operator
Customer
Service
Operator,
Customer
Service
Operator
Operator
Operator
33