Herunterladen Inhalt Inhalt Diese Seite drucken

Accessories; Warranty; Spare Parts; Transport - Kärcher SB-Wash-E 10 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Interruption
Possible cause
base exchanger
No power supply
does not regen-
erate
Switch clock at the head of the base ex-
changer is wrong adjusted or, after an in-
terruption of the power supply was not
adjusted.
The water stays
No salt in the salt tank
hard after the re-
generartion
No sole suction
water input pressure is too low
Other interruptions can only be removed by
the Service.

Accessories

Attachment sets
Water filter G 1"
order number: 6.414-278
container
Cleaning agent container 25 liter
order number: 6.393-474
Without content.
Cleaning agent container 10 liter
order number: 6.393-480
Without content.
Lid for the cleaning agent container 10 liter,
order number: 6.393-045
Fuel
Motor oil 0-W40
Best.-Nr.: 6.288-218
Silicon grease
Order no. : 6.288-072.0
Lock grease
Order no. : 6.288-116.0
Moisture protection spray
Best.-Nr.: 6.288-001.0
Steel care product
Order no. : 6.290-911.0
Water softening salt in form of tabletts
order number: 6.287-016
25 kg, for option base exchanger
Softener RM 110
For the optional softener:
Detergent
Warning!
Before using the cleaning agent, please re-
fer to the notice on the package. Do not use
the following cleaning agents:
cleaning agent containing nitrit acid
cleaning agent containing active chlo-
rinate
If you use such cleaning agents, it will dam-
age your equipment.
34
Interruptions at the base exchanger (optional)
Repair
Check power supply (fuse, switch, jack).
Set the time at the switch clock.
Fill in salt, let the level of the salt not get below the wa-
ter level.
Increase the water pressure to the minimum of 0,2
MPa (2 bar) .
CHEM 1
RM 806 ASF
CHEM 2
RM 820 ASF
The cleaning agents are to be used undilut-
ed.
Lime solvent
RM 100 ASF
RM 101 ASF

Warranty

The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of your accessory within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication. In the event of a warran-
ty claim please contact your dealer or the
nearest authorized Customer Service cent-
er. Please submit the proof of purchase.

Spare parts

Only use accessories and spare parts
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.
For additional information about spare
parts, please go to the Service section
at www.kaercher.com.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.

Storage

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
EN
Dosing ml/
min
Notice
25
The equipment may only be installed by an
15
mechanic of Kärcher
or an from Kärcher authorized individu-
al
Preparing the installation place
The following requirements are necessary
in order to install the equipment:
Straigh even area, with a solid subsoil
with the measures of 1040x725 mm.
For the option of the base exchanger/
Osmose an additional area of 845 x 725
mm.
Using the option of the base exchanger/
Osmose: Water connection with pipe
separator according to DIN 1717, per-
forming data, refer to " technical data".
Please pay attention to the national re-
quirements (in Germany DVGW).
Power connection, refer to "technical
data".
By customer, lockable, access for the
wash customer emergency - off- main
switch.
Light at the washing area according to
the national requirements, in order to
assure safe working for the customer
when dark.
Power and water supply according to
the measuring sheet.
By operation in the winter, an isolated/
heated water supply sytem must be
guaranteed.
Drain water shaft and required drain
water disposal.
Drill fixing holes according to the meas-
ure sheet.
Unpack the equpiment and dispose of the
packing material properly.
13
-
By whom
Operator,
Maintenance
Operator
Operator
Operator
Installing the unit
(only for experts)
Unpack the equipment

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sb-wash-e 5

Inhaltsverzeichnis