Water Supply; Spray Lance With High Pressure Nozzle; Spray Lance With Dirtblaster; Washing Brush - Kärcher K 2 Home T150 Bedienungsanleitung

Illustration

Connect high pressure hose to trigger gun.

Push the clamp in until it locks. Check the se-
cure connection by pulling on the high-pres-
sure hose.

Water supply

According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by KÄRCHER;
or, as an alternative, a system separator as per
EN 12729 Type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Caution
Always connect the system separator to the wa-
ter supply, never directly to the appliance!
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.

Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).

Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Caution
Dry runs lasting longer than two minutes lead to
damages to the high pressure pump. If the appli-
ance does not build up pressure within two min-
utes, switch it off and proceed as instructed in
the Chapter "Troubleshooting".
Illustration

Connect the high pressure hose to the high
pressure connection of the appliance.
Illustration

Push the spray lance into the trigger gun and
fasten it by turning it through 90°.

Completely open the water tap.

Insert the mains plug into the socket.

Turn on the appliance "I/ON".
14
Start up
Danger
The handgun is subjected to a recoil force when
the water jet is discharged. Make sure that you
have a firm footing and are also holding the
handgun and spray lance firmly.
Illustration

Unlock the lever on the trigger gun.

Pull on the lever of the trigger gun; the device
will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.

Spray lance with high pressure nozzle

For normal cleaning tasks.
Not suitable for use with detergents.

Spray lance with Dirtblaster

For particularly dirty items or areas.
Not suitable for use with detergents.
Spray lance with pressure regulation (Vario
Power)
Carrying out the most common cleaning tasks.
The work pressure can be stagelessly regulated
between "Min" and "Max". You can add deter-
gent when "Mix" is selected.

Release the lever on the trigger gun.
Illustration

Turn the spray pipe to the desired position.

Washing brush

Suitable for use with detergents.
Rotary washing brush
Suitable for use with detergents.
The rotating washing brush is ideally suited for
the cleaning of vehicles.
Caution
Please make sure that the washing brush is free
from dirt or other particles. Otherwise, it may
damage the paint work.
Working with detergent
Please use exclusively KÄRCHER detergents
and care products to carry out the respective
cleaning task, as these were specifically devel-
oped for your appliance. The use of other deter-
gents and care products may lead to premature
wear and can invalidate your warranty claims.
Please obtain information at your local dealer or
request information directly from KÄRCHER.
Illustration

Pull detergent suction hose as far as is re-
quired out of the housing.

Suspend end of detergent suction hose in a
container filled with detergent.
– 7
EN
Operation