C) Resetting The Speed Controller - Reely Generation X 6S Bedienungsanleitung

• Function #5, green LED flashes 1x long: Maximum braking strength
The speed controller unit allows proportional braking strength depending on the setting of the transmitter lever. The
maximum braking power at full lever extension can be adjusted to 25%, 50%, 75% and 100%.
A high setting (e.g. 100%) decreases braking distance but has a negative effect on the lifetime of the drive (specifi-
cally for the drive pinion and the main gear).

c) Resetting the Speed Controller

This function will reset all settings that were adjusted when setting up the speed controller unit to the original factory
settings (see grey marker in the table in chapter 10. b).
Proceed as follows:
• Switch on the transmitter. Leave the throttle/brake lever in its neutral position and do not move it.
• Switch on the speed controller (move the slider towards the setup button). The vehicle should now be ready for
operation; no LED is lit on the speed controller.
• Keep the setup button pushed until the red and the green LEDs flash slowly at the same time (using a duo-LED will
produce a mixed colour in amber/orange).
• Turn off the speed controller (switch to „OFF"; see figure in chapter 10. a) or b). All settings are then reset to the
factory setting, see table in chapter 10. b).
For reprogramming of the speed controller, observe the above chapters 10. a) and b).
Important!
If you use LiPo batteries to operate the vehicle, check the basic settings of the speed controller for whether
undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the
LiPo batteries will otherwise suffer deep discharge and be destroyed.
53