Commissioning; A) Remove Car Body; B) Installing The Receiver Aerial Cable; Inserting Batteries/Rechargeable Batteries In The Transmitter - Reely Generation X 6S Bedienungsanleitung

9. Commissioning

a) Remove Car Body

Pull the safety clips out and take off the car body upwards.

b) Installing the Receiver Aerial Cable

Route the aerial cable through the enclosed aerial tube
and plug it into the corresponding holder next to the re-
ceiver box; see arrow in the figure on the right.
For a wide range, the aerial needs to protrude from the
vehicle as vertically as possible.
The aerial cable may still be in the receiver box at delivery
of the vehicle. In this case, open the receiver box by pull-
ing out the safety clips so that the lid of the receiver box
can be taken off.
Ensure that the aerial cable is not damaged. Never shorten the aerial cable! Never coil the aerial cable!
This greatly reduces the range!
c) Inserting Batteries/Rechargeable Batteries in the Transmitter
Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Ob-
serve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment
again.
Observe the enclosed operating instructions for the remote control system.

d) Taking the Transmitter into Operation

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.
If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.
45