C) Driving The Vehicle - Reely Generation X 6S Bedienungsanleitung

c) Driving the Vehicle

• Improper operation can cause serious damage to people and property! Only drive with the model directly
in view. This is why you shouldn't drive at night.
• Only drive when your ability to react is unimpaired. Tiredness or the influence of alcohol or medication
can cause incorrect responses, just as with real vehicles.
• Please note that this model car must not be driven on public roads, places or streets. Also do not operate
it on private grounds without the owner's permission.
• Don't drive towards animals or people!
• Avoid driving at very low outdoor temperatures. Plastic parts lose elasticity, which may lead to damage
even in a light accident.
• Do not drive in thunderstorms; don't drive under high-voltage power lines or in the proximity of radio
masts.
• As long as the vehicle is in operation you must always leave the transmitter switched on.
• When parking the vehicle, always switch off the vehicle's speed controller first and disconnect the two
drive batteries from the speed controller completely then. Now you may turn off the transmitter.
• If the batteries (or rechargeable batteries) in the transmitter are weak, their range decreases. Exchange
the batteries or rechargeable batteries for new ones.
When the car's two drive batteries are weak, the car gets slower or no longer responds correctly to the
transmitter.
The drive batteries in the vehicle are not only used for supplying the engine via the speed controller. The
speed controller also generates the voltage/current required for operating the receiver and the steering
servo.
For this, the speed controller has an integrated BEC („Battery Eliminator Circuit"; electronic circuit for
direct voltage supply of the receiver without additional receiver battery).
If the voltage in the drive batteries is too low, the voltage at the receiver may also drop, causing the
vehicle to no longer respond to the control commands at the transmitter.
In this case, stop driving at once (switch off speed controller, disconnect drive batteries from vehicle,
switch off transmitter). Then replace the drive batteries of the vehicle or recharge the drive batteries.
• The motor and drive as well as speed controller and drive batteries of the vehicle get hot during opera-
tion. Wait at least 5 to 10 minutes before exchanging the rechargeable battery.
Let the drive batteries cool down completely before charging it.
Do not touch the motor, the speed controller or the rechargeable batteries until they have cooled down.
Danger of burns!
• Always observe that the undervoltage recognition is on when operating the LiPo drive battery (we re-
commend 3.0 V/cell or more).
With the undervoltage recognition deactivated, the LiPo batteries will suffer deep discharge and be
destroyed. Loss of guarantee/warranty!
41