Remote Controller Mode Settings; Remote Slave Flash Mode - Metz Mecablitz 52 AF-1 Pentax digital Bedienungsanleitung

9.2 Remote controller mode settings

In remote control mode the flash of the
master flash unit only assumes the control
function and does not contribute to exposure
of the shot!
9.2.1 Remote controller mode settings
• Switch on the flash unit with the
• Press the sensor button of the displayed
P TTL
-7,9 m
0,7
m
Z
F4.0
35
OOM
m
EV
INFO
MASTER
• Press the
k
SLAVE
• Press the
REMOTE
CONTROL
Remote controller mode is set.
Z 35
OOM mm
INFO
158
button. The start screen appears.
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
sensor buttons on the
CONTROL
touch display and select
CONTROL
sensor button on the
touch display.
.

9.3 Remote slave flash mode

The flash unit supports the wireless Pentax
P TTL remote system.
At the same time, one or more slave flash
units can be remotely controlled from one
master flash unit on the camera (e.g. meca-
blitz 52AF-1P digital).
So that multiple remote systems in the same
room do not interfere with one another, there
are four independent remote channels avai-
lable (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode .
Depending on the camera model, the came-
ra's internal flash unit can also function as
master flash unit. Please consult the respec-
tive camera operating instructions for further
tips on setting the master flash unit.