Switching The Flash Unit On And Off; The Selection Menu - Metz Mecablitz 52 AF-1 Pentax digital Bedienungsanleitung

3.3 Switching the flash unit on and off

• Switch on the flash unit with the
The
52AF-1
mode. To switch off the flash unit, press
PEN
the
+
If the flash unit will not be used for an exten-
ded period of time, we recommend that you
switch off the flash unit with the
ton and remove the power source (disposa-
ble/rechargeable batteries).

3.4 The selection menu

• Press the
k
The selection menu is divided into 4 sensor
buttons:
The modes of operation can be set after
pressing the
P TTL, see 6.1
P TTL HSS*, see 6.4
M, see 6.3
SPOTBEAM , see 6.5
MASTER, see 9.1
CONTROL, siehe 9.2
SLAVE, see 9.3
SERVO, see 9.5
*) only after data exchange with a camera
142
The start screen appears.
The flash unit always switches on after-
wards with the mode of operation that was
used last (e.g. manual flash mode M).
D
button flashes red in stand-by
button until all displays turn off.
D
button as often as it takes
for the selection menu to appear.
MODE
button.
button.
but-
The flash parameters can be set after
PARA
pressing the button.
EV (exposure correction),
see 6.1, 7, 9.2.1
Zoom (reflector setting), see 10.2
F (aperture)
ISO (light sensitivity),
P (partial light output), see 6.3, 9.3.4 and
9.1.3
3)
CHANNEL (Channel), see 9.1.3
2) only in MASTER mode
3) only in SLAVE mode
The touch display can be configured after
SERVICE
pressing the button, or the flash unit
can be reset to the factory setting.
CONTRAST , see 13.1
BRIGHTNESS , see 13.2
ROTATION (rotate the screen display),
see 13.3
RESET, see 14.3