Setting Partial Light Output Correction; Testing Remote Flash Mode - Metz Mecablitz 52 AF-1 Pentax digital Bedienungsanleitung

9.3.4 Setting partial light output correction

REMOTE
CH
M
SLAVE
1
• Press the sensor button on the touch dis-
Z
35 mm
OOM
INFO 1/1
• Press the
1/1
-1
1/1 /
3
-2
1/8 /
3
1/16 • Press the sensor button for the desired
-1
1/16 /
3
REMOTE
CH
M
SLAVE 1
k
The setting is applied immediately.
Z
35 mm
OOM
INFO 1/16
160
play for the partial light output/exposure
1/1
correction (e.g ) . The window for the
selection appears.
sensor buttons on the
touch display and set the desired exposure
correction (e.g. +1).
1/16
exposure correction value .

9.4 Testing remote flash mode

• Place the slave flash units in the desired
positions for the shot. Use flash unit moun-
ting foot S60 to set up the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF measuring
beam will blink.
• Press the manual firing button on the
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the sla-
ve flash unit so that it is able to receive
light from the master flash unit via the sen-
sor .
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.