Remote Slave Flash Mode Settings; Setting The Slave Channel; Set Slave Mode - Metz Mecablitz 52 AF-1 Pentax digital Bedienungsanleitung

9.3.1 Remote slave flash mode settings

• Switch on the flash unit with the
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. M flash mode).
P TTL
• Press the displayed mode of operation on
the touch display as many times as it takes
-7,9 m
0,7
for the display for selecting the mode of
m
Z
F4.0
35
OOM
operation to appear.
m
EV
INFO
MASTER
• Press the
SLAVE
touch display and select "SLAVE".
SERVO
• Press the
touch display.
Remote slave mode is set.
REMOTE CH
TTL
SLAVE 1
In addition, the selected flash mode (e.g.
Z
35 mm
OOM
TTL) and the remote channel (e.g. CH 1) are
displayed.
EV
INFO
sensor buttons on the
SLAVE
sensor button on the

9.3.2 Setting the slave channel

REMOTE CH
TTL
SLAVE 1 • Press the sensor button on the touch dis-
play for the channel group (e.g.
Z
The window for selecting the channel and
35 mm
OOM
group appears.
EV
INFO
• Press the sensor buttons on the touch
display for the channel "CH".
• Press the
touch display and select the desired
channel.
• Press the selected channel on the touch
display.
The setting will take effect immediately.

9.3.3 Set slave mode

• Press the sensor button on the touch dis-
REMOTE
CH
TTL
SLAVE
1
play for the partial light output/exposure
correction (e.g.
Z
35 mm
OOM
the selection appears.
EV
INFO
• Press the sensor buttons on the touch dis-
play for the channel "MODE".
• Press the sensor button on the touch dis-
play for the desired mode of operation
M
M
or .
TTL
The setting is applied automatically.
TTL I CH1
).
sensor buttons on the
k
TTL I CH1
). The window for
TTL
159