Remote Master Mode Settings - Metz Mecablitz 52 AF-1 Sony digital Bedienungsanleitung

10.1 Remote master mode settings

The slave groups RMT and RMT2 are activated
at the factory.
The master flash unit (CTRL) and the slave
groups RMT and RMT2 can be activated or
deactivated!
If the master flash (CTRL) unit is deactivated,
it only controls the slave units and does not
contribute to exposing the shot!
10.1.1 Remote master mode settings
• Switch on the flash unit with the
TTL
button. The start screen appears.
-7,9 m
0,7
• Press the sensor button of the displayed
m
Z
F4.0 mode of operation on the touch display as
35
OOM
m
many times as it takes for the display for
EV
INFO
selecting the mode of operation to appear.
M HSS
• Press the
MASTER
touch display and select
Slave
• Press the
touch display. Remote master mode is set.
REMOTE TTL
CTRL +
Remote master mode is shown in the picture.
CTRL RMT RMT2
Remote master mode CTRL+ is shown in the
1 1 1
picture. The master (CTRL) contributes in the
same light conditions to exposure at the
INFO RATIO
slave flash groups (RMT) .
sensor buttons on the
MASTER
.
MASTER
sensor button on the
Light conditions can be assigned to master
(CTRL) and slave flash group RMT or slave
flash group RMT2 (see 10.1.2).
Switch from CTRL to CTRL+
D
• Press the
for the selection menu to appear.
• Press the
touch display.
RATIO
• Press the
CTRL
touch display and select "CTRL".
CTRL
• Press the
display.
CTRL
• Press the sensor button on the touch
display for the desired mode of operation
CTRL+
CTRL
or alternatively
The setting will take effect immediately.
+
Light condition control (ratio) is only
possible in CTRL+ mode.
button as often as it takes
PARA
sensor button on the
sensor buttons on the
sensor button on the touch
CTRL+
.
161
k