Remote Master Mode Settings; Remote Channel Settings; Remote Slave Flash Mode - Metz Mecablitz 64 AF-1 digital -Olympus-Panasonic-Leica Bedienungsanleitung

10.1 Remote master mode settings

RC mode is in general set on the camera.
If the master flash unit is deactivated, it only
controls the slave units and does not contri-
bute to exposing the shot.
10.1.1 Remote master mode settings
• Switch on the flash unit with the
REMOTE
MASTER
button.
The start screen appears.
m
28
Zoom • Set RC mode on the camera.
m
Remote master mode is shown in the picture.

10.1.2 Remote channel settings

There are four independent remote channels
to use so that multiple remote systems in the
same room do not interfere with one another.
Master and Slave flash units belonging to the
k
same remote system must be set to the same
remote channel.
The RC mode must be set on the camera and
is transmitted to the flash units involved after
a test flash.
168

10.2 Remote slave flash mode

The flash unit supports Olympus`s wireless
TTL Remote System in slave flash mode. At
the same time, one or more slave flash units
can be remotely controlled from one master
flash unit on the camera (e.g. mecablitz 64
AF-1 O digital).
A slave flash unit can be assigned to one of
three possible slave groups (GROUP A, B or
C). The master flash unit can control all of
these slave groups simultaneously and at the
same time take the settings for each slave
group into account.
So that multiple remote systems in the same
room do not interfere with one another, there
are four independent remote channels avai-
lable (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode .
Depending on the camera model, the came-
ra's internal flash unit can also function as
master flash unit.