Automatic High-Speed Synchronisation (Hss) - Metz Mecablitz 52 AF-1 Pentax digital Bedienungsanleitung

Manual partial light output levels
Partial light output can be set in manual flash
mode
Setting procedure
M
• Press the sensor button for partial light out-
7,9 m
m
Z
F4.0
35
OOM
m
INFO 1/1
• Press sensor buttons
1/1
7,9m
1/1 -1 / • Press the sensor button on the touch dis-
3
The setting is immediately effective and
automatically saved.
1/16
The distance display is adjusted to the partial
1/16 -1 /
k
3
light output automatically (see 5.2).
1/16 -2 /
3
150
M
.
put on the touch display as many times as
it takes for the partial light output display
to appear.
touch display and set the desired partial
light output to 1/1, 1/2, 1/8 or 1/128.
play for the selected partial light output.
on the
6.4 Automatic high-speed synchronisa-
tion (HSS)
Various cameras support automatic high-
speed synchronisation (see the camera's
operating instructions). This flash mode
makes it possible to use a flash unit even
with shutter speeds that are faster than the
flash sync speed.
Interesting results may by achieved in this
mode when, for example, a wide open aper-
ture (e.g., f/2.0) is used to limit the depth of
field in portrait shots taken in very bright
ambient light. The flash unit supports high-
P TTL HSS
speed synchronisation in
mode.
For physical reasons, however, high-speed
synchronisation significantly reduces the
number and the maximum flash range.
Be sure to note, therefore, the flash range on
the display of the flash unit. High-speed syn-
chronisation is activated automatically if a
shutter speed faster than the flash sync
speed is set on the camera, whether manual-
ly or automatically by the exposure program.
Note that in the case of high speed synchro-
nisation the guide number of the flash unit
also depends on the shutter speed.
The faster the shutter speed, the lower the
guide number!
flash