Remote Controller Mode Settings; Remote Master Mode Settings; Remote Slave Flash Mode - Metz Mecablitz 64 AF-1 digital -Pentax Bedienungsanleitung

10.2 Remote controller mode settings

In remote control mode the flash of the
master flash unit only assumes the control
function and does not contribute to exposure
of the shot!

10.2.1 Remote master mode settings

• Switch on the flash unit with the
button.
The start screen appears.
PTTL
• Press the sensor button of the displayed
mode of operation on the touch display as
0.8- 9.0 m
many times as it takes for the display for
selecting the mode of operation to appear.
M-
5,6
35 m
F
Zoom
m
EV
• Press the
O
MODE
touch display and select
REMOTE MASTER
• Press the
REMOTE CONTROL
the touch display.
REMOTE SLAVE
p
q
REMOTE
CONTROL
Remote master mode is set.
M-
Zoom 35 m
m
sensor buttons on the
REMOTE CONTROL
.
REMOTE CONTROL
sensor button on

10.3 Remote slave flash mode

The flash unit supports the wireless Pentax P
TTL remote system.
At the same time, one or more slave flash
units can be remotely controlled from one
master flash unit on the camera (e.g. meca-
blitz 5 64AF-1C digital).
So that multiple remote systems in the same
room do not interfere with one another, there
are four independent remote channels avai-
lable (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode .
Depending on the camera model, the came-
ra's internal flash unit can also function as
master flash unit.
k
187