Zoom Mode - Metz Mecablitz 52 AF-1 Pentax digital Bedienungsanleitung

• the shutter release is actuated
• the camera's exposure metering system is
switched off. . .
. . . switched to stand-by mode, (Auto-OFF) to
save energy and to protect the power source
from unintentional discharging. The active
automatic unit switch-off is shown in the
INFO display.
The flash ready indicator
tors on the LC display disappear.
The
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
k
the shutter release (wake-up function).
+
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
using the main switch
to be used for an extended period.
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
144
and the indica-
D
button flashes red in stand-by
D
button, or by tapping on
if it is not going
Setting the automatic unit switch-off
• Switch on the flash unit with the
button. The start screen appears. The
flash unit always switches on afterwards
with the mode of operation that was used
last (e.g. manual flash mode M).
• Press the
for the selection menu to appear.
• Press the
touch display.
• Press the

ZOOM MODE

touch display and select „STANDBY".
STANDBY
MOD.LIGHT
• Press the
touch display.
• Tap the sensor button on the touch display
for the desired time. The setting is adopted
Off
immediately. The operation display appe-
41 min
ars after about 10 seconds, or press the
10 min
button repeatedly until the operation
display appears.
D
The button flashes red in stand-by
mode.
D
button as often as it takes
OPTION
sensor button on the
sensor buttons on the
STANDBY
sensor button on the
D