Spotbeam Mode - Metz Mecablitz 52 AF-1 Pentax digital Bedienungsanleitung

The setting for automatic high-speed syn-
chronisation occurs on the camera (see
camera operating instructions)!
The display of the flash unit then in addition
HSS
shows .

6.5 SPOTBEAM mode

In the SPOTBEAM mode, the AF measuring
beam can be used to focus on a subject at
low ambient light level without firing a flash
when the shot is taken.
There is no flash-ready indicator in
SPOTBEAM mode and no exposure control
indicator in the camera viewfinder. The came-
ra is not set to its sync speed and behaves as
though there were no flash unit connected.
+
SpotBeam mode is only activated when the
flash unit is switched on and is flash-ready
(check the flash-ready indicator on the flash
unit!).
When the camera shutter is released, no
flash is fired.
Please read the notes on the AF measuring
beam in chapter 10.3 AF-BEAM.
Setting the mode of operation
• Switch on the flash unit with the
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last.
P TTL
• Tap the shutter release to transfer data bet-
-7,9 m
0,7
ween the flash unit and the camera.
m
Z
F4.0
35
OOM
m
EV
INFO
1
+ 1/3
• Press the sensor buttons
touch display and select „SPOTBEAM" .
M
SPOTBEAM
• Press the sensor button on the touch dis-
MASTER
SPOTBEAM
play
SPOTBEAM
The setting will take effect immediately.
INFO
on the
.
151
k