Remote Master Mode Settings - Metz Mecablitz 64 AF-1 digital -Sony Bedienungsanleitung

10.1 Remote master mode settings

The slave groups RMT and RMT2 are activated
at the factory.
The master flash unit (CTRL) and the slave
groups RMT and RMT2 can be activated or
deactivated!
If the master flash (CTRL) unit is deactivated,
it only controls the slave units and does not
contribute to exposing the shot.
10.1.1 Remote master mode settings
• Switch on the flash unit with the
button.
TTL
The start screen appears.
• Press the sensor button of the displayed
0.6- 7.2 m
mode of operation on the touch display as
many times as it takes for the display for
M-
m
35
Zoom
m selecting the mode of operation to appear.
EV
• Press the
touch display and select
k
O
MODE
• Press the
STROBO
the touch display.
REMOTE MASTER
Remote master mode is set.
REMOTE SLAVE
Remote master mode CTRL+ is shown in the
p
q picture. The master (CTRL) contributes in the
same light conditions to exposure at the sla-
ve flash groups (RMT).
TTL
REMOTE
CTRL
CTRL RMT
Light conditions can be assigned to master
(CTRL) and slave flash group RMT or slave
4 8
flash group RMT2 (see 10.1.4).
RATIO
182
sensor buttons on the
REMOTE MASTER
.
REMOTE MASTER
sensor button on
Switch from CTRL to CTRL+
• Press the
for the selection menu to appear.
• Press the
PARAMETER
touch display.
PARAMETER O
• Press the
RATIO
touch display and select
CONTROL
• Press the
touch display.
p
q
CTRL/CTRL+ O
• Press the sensor button on the touch
CTRL
display for the desired mode of operation
CTRL
or alternatively
CTRL+
TTL
REMOTE
CTRL+
The setting will take effect immediately
CTRL RMT RMT2
4 8 1
RATIO
+
Light condition control (ratio) is only possi-
ble in CTRL+ mode.
D
button as often as it takes
PARAMETER
sensor button on the
sensor buttons on the
CONTROL
.
CONTROL
sensor button on the
CTRL+
.