Yamaha AV-S77 Bedienungsanleitung Seite 27

Note
• If a thudding noise is heard from the subwoofer when the B.
BOOST function is turned on or when you play a bass-enhanced
source such as 5.1 channel Dolby Digital or DTS which contains
Low Frequency Effect, lower the subwoofer level. Otherwise, the
subwoofer may be damaged due to an excessive input level of
low-bass signal.
Î Muting the sound temporarily
Press MUTE.
MUTE
y
• "Mute ON" is displayed when the sound is muted.
To return to the original volume level, press MUTE again.
Pressing VOL +/– also cancels the muting mode and adjusts
the volume level.
‰ Calling Up Your Favorite Settings
Each MEMORY 1, 2 or 3 button can memorize the current
input and the settings of DSP mode, subwoofer channel
level, B. BOOST mode and NIGHT mode. Once the settings
are preset, you can call up each MEMORY 1, 2 or 3 button
anytime by simply pressing one of the MEMORY buttons.
Memorizing the settings to each MEMORY 1, 2
or 3 button
Press and hold the MEMORY 1, 2 or 3 button to be
memorized for about 3 seconds.
—— MEMORY ——
1
The number of the button you pressed is displayed after
"Memory" and the current settings are memorized.
Ex. : When the MEMORY 1 button is pressed,
"Memory 1" is displayed.
Calling up the favorite button's memory
Press the MEMORY 1, 2 or 3 button to select the
desired settings.
The number of the button you pressed is displayed after
"Memory" and the favorite settings are selected.
• If you keep pressing the button for more than 3
seconds, the previously memorized setting will be
replaced with the current settings.
2 3
Clearing the button's memory
Press and hold the MEMORY 1, 2 or 3 button to be
cleared for about 10 seconds. The number of the button
you pressed is displayed after "MemoryClear" and the
memorized settings are cleared. (When pressing the
button, "Memory 1 (2 or 3)" is displayed after about 3
seconds, but keep pressing the button.)
• If you release the button before the display changes
from "Memory" to "MemoryClear", the button
memorizes the current setting.
Ï Setting the main display
You can set the main display to "input name" or "DSP
program name."
Pressing DISPLAY changes the main display
between "Disp: INPUT" and "Disp: DSP."
DISPLAY
When you operate any button, the appropriate display
appears. After a few seconds, the display returns to the main
display, "input name" or "DSP program name."
USING CONVENIENT FUNCTIONS
E-
25