Yamaha AV-S77 Bedienungsanleitung Seite 25

I Switching the input mode
This function allows you to switch the input mode of the
component connected to the DIGITAL 1 or DIGITAL 2
terminal to "Auto Mode" or "dts Fix".
Auto Mode : This recognizes the PCM signal such as a CD,
Dolby digital signal or DTS signal
automatically.
dts Fix : This fixes to a DTS signal.
Normally, playback can be performed in the "Auto Mode".
If you play a CD encoded with DTS in the "Auto Mode"
setting, there will be a short noise at first while the unit
recognizes the DTS signal and turns on the DTS decoder.
Also, the indicator may flash when a search or skip
operation is performed. If this status continues for about 30
seconds, the unit will automatically switch from the DTS-
decoding mode to PCM digital signal input mode, and the
indicator will go off. This is not a malfunction and can
be avoided by setting the input mode to "dts Fix"
beforehand.
When you play and stop a CD encoded with DTS in the
"Auto Mode" setting, the sound is muted even if you play
the PCM signal such as a normal CD and the
flashes for about 30 seconds. However, this condition is
released after about 30 seconds.
1
Press the INPUT selector button ( or INPUT
on the remote control) to select DIGITAL 1
g
or DIGITAL 2.
INPUT
Front panel
2
Press the same button again for about 3
seconds to switch the input mode.
Each time the button is pressed for about 3 seconds, the
input mode is switched between "Auto Mode" and "dts
Fix", and displayed as follows.
"D1← dts Fix"
• "D1" or "D2" is displayed before the selected input
mode when DIGITAL 1 or DIGITAL 2 is selected
respectively.
y
• The indicator lights when "dts Fix" is selected, and goes off
when a digital signal encoded with DTS is not input in the "Auto
Mode" setting.
• The setting of the input mode returns to "Auto mode" when the
power of this unit is in standby mode.
• When playing a source encoded with DTS, be sure to connect the
player to the DIGITAL 1 or DIGITAL 2 input terminal of the
control center with an optical fiber cable.
• If the digital output data of the player has been processed in any
way, you may not be able to perform DTS decoding even if you
make a digital connection between this unit and the player.
indicator
h /
h
INPUT
or
g
Remote control
"D1←Auto Mode"
CAUTION
If a source is played back at maximum volume enough to
distort the sound for a long time, the speakers may be
damaged.
I Listening through the headphones
Connect the headphones to the PHONES jack on the rear
panel of the subwoofer.
When you turn on EFFECT, the unit automatically selects
the Silent Cinema program suitable for the headphones. You
can enjoy the three-dimensional virtual surround even
through the headphones.
Subwoofer
DO NOT CONNECT THIS UNIT TO
SPEAKERS OTHER THAN AV-S77C,
NX-S77E
SPEAKERS
PHONES
SILENT
MARK SYSTEM MARK
(BLACK) (WHITE)
CONNECTOR
Note
• When disconnecting the headphones plug, confirm the location of
the PHONES jack, then hold the headphones plug and pull out it.
Do not pull the cord itself.
I After using the unit
Press p to set the unit to standby mode.
/I
Front panel
The subwoofer is also set to standby mode. To turn off the
power completely, disconnect the power supply cord of the
subwoofer from an AC outlet.
OPERATING THE UNIT
Connect the
headphones.
POWER
or
Remote control
23
E-