To Mute The Sound - Yamaha DSP-AX620 Bedienungsanleitung

To select a source connected to the 6CH INPUT
jacks
Press 6CH INPUT until "6CH INPUT" appears on the
front panel display and on the video monitor.
6CH INPUT
Front panel
Notes
• If "6CH INPUT" is shown on the front panel display and on
the video monitor, no other source can be played. To select
another input source with INPUT l / h (or the input selector
buttons), press 6CH INPUT to turn off "6CH INPUT" from the
front panel display and the video monitor.
• If you want to enjoy an audio source connected to the 6CH
INPUT jacks together with a video source, first select the video
source and then press 6CH INPUT.
4
Start playback (or select a broadcast station)
on the source component.
Refer to the operation instructions for the
component.
5
Adjust the volume to the desired output
level.
VOLUME
Front panel
If desired, use BASS, TREBLE and BASS
EXTENSION etc. These controls are only effective
for sound from the main speakers.
BASS
EXTENSION
ON OFF
Front panel
Note
• If the component connected to the VCR 1 OUT, VCR 2/DVR
OUT and MD/CD-R OUT jacks is turned off, the reproduced
sound may be distorted or the volume may be lowered. In these
cases, turn on the component.
or
Remote control
or
Remote control
BASS TREBLE
+ +
– –
6
Use the digital sound field processor.
See "Selecting a Sound Field Program".
DSP
PROGRAM
Front panel
or
Remote control

To mute the sound

Use this when you want to temporarily mute audio
output.
Press MUTE on the
remote control.
To restore the audio output to
the previous volume level,
press MUTE again.
y
• You can also cancel mute to press any operation buttons such as
VOLUME +/–.
• During muting, "MUTE ON" appears on the front panel
display and on the video monitor.
When you have finished using
this unit
Press STANDBY/ON (or STANDBY) to set
this unit in the standby mode.
Notes on the digital signal
The digital input jacks of this unit can also handle
96-kHz sampling digital signals. (To utilize this, use a
source that supports 96-kHz sampling digital signals and
set the player for digital output. Refer to the operation
instructions for the player.) Note the following when a
96-kHz sampling digital signal is input to this unit:
1. The following indication will appear on the front panel
display.
V-AUX VCR2/DVR VCR 1 D-TV/CBL
PCM
2. DSP programs cannot be selected. Sound will be
output as normal 2-channel stereo sound from only the
left and right main speakers.
Note
• If "1B MAIN SP" on the SET MENU is set to SMALL and
"1D LFE/BASS OUT" is set to SWFR, or "1D LFE/BASS
OUT" is set to BOTH, the sound is also output from the
subwoofer.
3. Adjustment of the speaker output level (except for
subwoofer output level) described on page 38 cannot
be made.
BASIC PLAYBACK
– +
DVD MD/CD-R TUNER CD PHONO
VOLUME
25