Profitec Pro 800 Bedienungsanleitung Seite 30

Problem
Little or no crema on the top of
the coffee
Little or no crema on top of the
coffee
Sparse coffee dispensing, only
drop by drop
Weak "body"
Foam instead of crema
The machine is switched on, but
the machine does not work.
The machine does not stop
working and takes in air.
Portafilter/ brew group is dripping.
If the machine will not be used for a long period of time, it is recommended to
.. clean the brew group (see instructions on page 29). Afterwards, please do not clamp the portafilter back
into the group.
..to empty the boilers. Turn the switch of the operational machine to position off. Open the hot water valve
and the boiler water is now discharged by the remaining pressure through the hot water release. Close the
hot water valve after the water has been released. The coffee boiler is emptied out via the brew group.
Activate the brew group lever and release the water into the drip tray. Please make sure some water remains
in the coffee boiler. Start-up of the machine is the same as initial start-up (item 5.1).
Bedienungsanleitung/Instruction manual PRO800
Possible Cause
The grind is not fine enough.
The coffee is too old.
There is too much chlorine in the
water.
The amount of ground coffee is
not enough.
The grind is too fine.
There is too much ground coffee.
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The beans are improper.
The setting of the coffee grinder is
not suited for the coffee beans in
use.
PID-display is turned off: There is
not enough water in the fresh
water tank.
Water has been refilled, PID-
display is off.
The floater is not in the correct
position.
The water tank is not situated
properly.
Machine in use with direct water
connection, but switch in
position "0" (= position water
tank). Machine does not take in
water.
Machine in use with water tank,
but switch in position "1" (=
position direct water connection).
Portafilter is not fixed properly.
Group gasket is broken.
29
Troubleshooting
Use a finer grind.
Tamp the ground coffee more
firmly.
Use fresh coffee.
Use a chlorine filter.
Use the right coffee amount:
Approx. 7g – 9g of coffee for each
cup.
Set a coarser grind.
Tamp ground coffee only slightly.
Use approx. 7g –9 g of coffee for
every cup.
Set a finer grind..
Use fresh coffee.
Use approx. 7g – 9g of coffee for
each cup.
Clean the shower screen.
Use another type of coffee bean.
Adjust the coffee grinder (When
changing the coffee beans,
changing the grind may also be
necessary.)
Refill water.
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct
position. (The side of the floater
with the magnet point must face
towards the inside of the machine.
The floater itself must be inserted
with the magnet point on the
lower part of the floater side).
Situate the water tank properly.
This switch is located behind a
cover panel at the back of the
machine.
This switch is located behind a
cover panel at the back of the
machine.
Fix the portafilter properly.
Change group gasket and shower
screen.
ENGLISH