Programming The Temperature Via The Pid-Display; Preparing Coffee - Profitec Pro 800 Bedienungsanleitung

6.2 Programming the temperature via the PID-display

Switch the machine on in order to activate the boiler. The temperature of the
boiler is of no importance in programming. The heater is inactive during
programming.
+ –
2. Press and at the same time until 't' appears on the display.
+
3. Press in order to progress to the submenu of 't' and to change the
temperature value. The nominal temperature value is displayed.
4. Quickly press
-
+
the nominal temperature value.

6.3 Preparing coffee

Caution!
Please use the included portafilters only. Otherwise there is a danger of injury.
Use the portafilter with 1 spout and the corresponding filter (1 cup) for the preparation of 1 cup. Use the
portafilter with 2 spouts and the big filter (2 cups) for the preparation of 2 cups. Make sure that the filter is
firmly locked into the portafilter.
Fill the finely ground coffee into the corresponding filter (approx. 7 – 8 g per cup). Compress the ground
coffee with the tamper (ø 58 mm). Clamp the portafilter firmly into the brew group.
Place the cup under the spout of the portafilter (for the preparation of 2 cups, put 1 cup under each spout).
Caution-danger of injury!
If the portafilter is not inserted properly, there is a great risk of injury. Never remove the
portafilter when there is remaining pressure in the piston of the brew group.
Caution-danger of injury!
Please leave enough distance between your face/body and the lever when brewing espresso.
By using some force to pull the lever down completely, hot water flows into the piston of the brew group. Pre-
infusion starts. Pull the lever up some and release it slowly. Now the lever slowly returns to its neutral
position. The espresso flows from the portafilter.
The longer you have pulled the lever down, the more hot water flows into the piston of the brew group.
Simply remove the cups from under the spouts once the desired amount of espresso has been brewed. The
remaining espresso coming from the portafilter can flow into the drip tray.
It is not possible to interrupt the brewing process. Do not remove the portafilter until the lever
is back in neutral position.
Bedienungsanleitung/Instruction manual PRO800
to decrease
to increase
24
ENGLISH