Dispensing Of Steam; Cleaning And Maintenance; General Cleaning - Profitec Pro 800 Bedienungsanleitung

When the machine is switched off, more hot water can be dispensed.
However, one does not necessarily have to switch off the machine for dispensing hot water.

6.5 Dispensing of steam

The PRO800 makes it possible to generate large amounts of steam in order to heat or froth beverages, e. g.
milk or punch. Therfore, within a few seconds, you can prepare milk froth. Please pay attention to the
instructions below. Do not bring the milk to a boil, otherwise frothing milk will not be possible.
1 Important: In order to get the best results when frothing milk, open the steam lever for approx. 5.
seconds to release the condensation water in the pipe. This also prevents milk from being sucked into
the boiler.
2 Immerse the steam nozzle (at the end of the steam dispenser) into the liquid.
3 Re-open the steam handle/steam lever.
4 Heat and/or froth the liquid.
5 After frothing or heating, release the steam into the drip tray to keep the holes of the steam nozzle clean.
You can purchase the following steam tips from your dealer:
2-hole steam tip, item no. P2543
4-hole steam tip, item no. P2542
Risk of injury
Always keep the steam nozzle underneath the surface of the liquid while heating or frothing in
order to avoid splashing.
Important
After every application, clean the steam nozzle and the steam dispenser with a non-abrasive,
damp cloth; This removes possible liquid residues.
Risk of injury
Avoid skin contact with the steam dispenser while cleaning!
7

CLEANING AND MAINTENANCE

A regular and accurate care is very important for the performance, the longevity and the safety of your
machine.
Caution!
Always switch off the machine (power switch in lower position), disconnect the power cord and
let the machine cool down to room temperature (for at least 30 minutes) before cleaning.

7.1 General cleaning

Daily cleaning:
Portafilter, filters, water tank, drip tray require daily cleaning. Clean with warm water and/or with a food safe
detergent.
Clean the shower screen and the group gasket in the lower part of the group and remove visible dirt without
disassembling the parts.
Cleaning as necessary:
Clean the steam and hot water valve after every use.
Clean the body when the machine is switched off and cold.
Use a soft, damp cloth for cleaning.
Never use abrasive or chloric detergents!
Empty the water drip tray regularly and do not wait until it is full.
Bedienungsanleitung/Instruction manual PRO800 26
ENGLISH