Installing User Modules - G&D DP1.2-Vision-CAT Bedienungsanleitung

Installing user modules

The remote console is connected to the
puter connected to the computer module can be operated from this console.
Establishing a connection to a local network
NOTE: If desired, connect the network interface to a local network. This enables
you to access the Config Panel
log messages to this network.
Network: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse of consoles
USB 2.0 Trans.
USB 2.0 Devices
Transmission DP Out
NOTE: Both the keyboard and the mouse of the console can either be PS/2 or USB
devices.
Connect the mouse and/or the keyboard of the console to this interface.
Keyb./Mouse:
Generic: In the default settings, you can use this interface to connect another USB
input device or a supported display or tablet.
Activate the generic HID
to connect another USB input device. In this mode, any data of the USB input device
is not altered when transmitted to the computer module.
IMPORTANT:
If the generic HID
keyboard connected to the
Keyb.: Connect the PS/2 keyboard of the console.
Connect the PS/2 mouse of the console.
Mouse:
DP1.2-Vision-CAT-CON
Power
Network
Red. Ident.
Main
web application from this network and to send sys-
Line In Speaker
mode (see Selecting the USB-HID mode on page 36) if you want
mode is active, the OSD cannot be operated by a
socket.
Generic
user module. The com-
USB Devices
K/M Ch. Status Service
1
Status
RS232
Red. Power
G&D DP1.2-Vision-CAT · 9
Installation
Fan In