G&D DP1.2-Vision-CAT Bedienungsanleitung Seite 77

Connecting further interfaces of ARU/ARU2 variants
USB 2.0 Trans.
USB 2.0 Devices
Transmission DP Out
Use the two interface on the back and the two interfaces on the front
USB 2.0 Devices:
to connect USB devices.
NOTE: The USB 2.0 Devices
data rates:
variants: full speed
 ARU
variants: high speed
 ARU2
USB 2.0 Trans. Plug a category 5e (or better) twisted pair cable, which is available as
accessory, into this interface of the
to the USB 2.0 Trans. interface of the computer module.
NOTE: Connect the USB 2.0 Trans.
card CCD-IO16-Card-MULTI if you want to connect the computer module to a
compatible matrix switch (see page 2).
Mind the notes in the paragraph Purpose and configuration of multi cards in the user
manual of the web application.
Establishing the power supply
USB 2.0 Trans.
USB 2.0 Devices
Transmission DP Out
Main Power: Insert one of the supplied IEC cables here.
To provide a second, redundant power supply, connect a portable power
Red. Power:
pack to this interface.
Generic
Line In Speaker Keyb./Mouse Keyb./Mouse
interfaces of ARU
variant. Connect the other end of the cable
ARU2
interface to one of the dynamic ports of the IO
Generic
Line In Speaker Keyb./Mouse Keyb./Mouse
RS232
Red. Power
and ARU2 variants support different
RS232
Red. Power
G&D DP1.2-Vision-CAT · 11
Installation