G&D DP1.2-Vision-CAT Bedienungsanleitung Seite 101

How to configure the Freeze mode:
1. Press Ctrl+Num
2. Select the row
The Freeze mode is adjusted separately for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
3. Under Freeze mode
off  Freeze mode is disabled (default)
on  Freeze mode is enabled
4. If the Freeze mode is active, press
under
Freeze visualization
frame  shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
OSD
frame+OSD  shows a coloured frame (
5. Press to save your settings.
F2
1. Click on KVM Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tabs
The Freeze mode is adjusted separately for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
4. Under
Freeze mode
(default)
Disabled
Enabled
5. If the Freeze mode is active, additionally select one or both options available
under
Freeze visualization
Frame  shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
OSD
6. Click to save your changes.
OK
(default) to open the on-screen display.
and press
Console setup
press F8 to select on of the following options:
F8 to select one of the options available
:
Remote > General .
select one of the following options (see above):
:
.
Enter
frame ) and Frozen ( OSD
on the directory tree.
G&D DP1.2-Vision-CAT · 35
Configuration
)