Installing The User Module; Connecting The Remote Console; Interfaces For Usb 2.0 Devices - G&D DVIVision-USB 2.0 Series Installationsanleitung

Installing the user module

Connecting the remote console

Speaker Micro In RS232
Transmission DVI/VGA Out
DVI/VGA Out: Connect the console monitor to this interface.
If the monitor only provides an analog VGA input, connect an optional adapter to
this interface. Afterwards, connect the monitor's VGA cable to the adapter.
NOTE: Both mouse and keyboard of the remote console can either be connected as
a PS/2 device or as a USB device.
USB Keyb.: Connect the USB keyboard to this interface.
Connect the USB mouse to this interface.
USB Mouse:
Keyb.: Connect the PS/2 keyboard to this interface.
Connect the PS/2 mouse to this interface.
Mouse:

Interfaces for USB 2.0 devices

USB 2.0: If desired, connect up to two USB devices to these interfaces at the front
panel of the user module.
Speaker Micro In RS232
Transmission DVI/VGA Out
USB 2.0 Devices: If desired, connect up to two USB devices to these interfaces at the
back panel of the user module.
The computer that is connected to the DVIVision-CPU computer module can now
use these devices in addition to the USB devices that are directly connected to the
computer.
Mouse
Keyb./Mouse Keyb. USB 2.0 Devices Red. Power
Mouse
Keyb./Mouse Keyb. USB 2.0 Devices
USB 2.0 Trans.
USB 2.0
Power Status
Red. Trans.
Sys.
Main
USB 2.0 Trans.
Red. Power
G&D DVIVision-USB 2.0 · 8
Installation
Console Service
Video
K/M