G&D DP1.2-Vision-CAT Bedienungsanleitung Seite 76

Installation
Connecting the console monitor
USB 2.0 Trans.
Transmission
DP Out: Connect the console monitor.
Establishing a connection to the computer module
USB 2.0 Trans.
Transmission
Plug a category 5e (or better) twisted pair cable, which is available as
Transmission:
accessory, into this interface. Connect the other end of the cable to the respective
interface of the computer module or to one of the Dynamic Ports of a compatible
matrix (see page 2).
Connecting audio and RS232 interfaces
USB 2.0 Trans.
Transmission
Line In: If required, connect a microphone to this interface.
Connect the speakers or another audio output device.
Speaker:
Connect the serial end device to this interface.
RS232:
10 · G&D DP1.2-Vision-CAT
USB 2.0 Devices
DP Out Line In Speaker Keyb./Mouse
USB 2.0 Devices
DP Out Line In Speaker Keyb./Mouse
USB 2.0 Devices
DP Out Line In Speaker Keyb./Mouse
RS232
Generic
Keyb./Mouse Red. Power
RS232
Generic
Keyb./Mouse Red. Power
RS232
Generic
Keyb./Mouse Red. Power