Changing The Scancode Set Of Ps/2 Keyboards - G&D DP1.2-Vision-CAT Bedienungsanleitung

1. Click on
KVM Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tab
board for the local console (at the
Click on the tab
cial keyboard for the remote console (at the
4. Under PS/2 keyboard type
default
PixelPower Blue
SKIDATA1
5. Click to save your changes.
OK

Changing the scancode set of PS/2 keyboards

If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe "|" or the arrow keys do not
work as expected.
if you want to adjust the support of a special key-
Local
CPU
Remote > General if you want to adjust the support of a spe-
select one of the following options:
 disables support of special keyboards
 enables support of keyboard PixelPower Blue
 enables support of keyboard SKIDATA1
on the directory tree.
module).
CON module).
G&D DP1.2-Vision-CAT · 39
Configuration