Changing The Scancode Set Of Ps/2 Keyboards - G&D VisionXS-C-DP-UHR Installation Und Bedienung

Configuration

Changing the scancode set of PS/2 keyboards

If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
ADVICE:
Use the scancode set 3 if you cannot enter the pipe "|" or the arrow keys
do not work as expected.
How to change the setting of the scancode set:
1. Press
Ctrl+Num
2. Select the row
3. Under
Scancode set
2  activates scancode set 2 for PS/2 keyboard inputs
 activates scancode set 3 for PS/2 keyboard inputs
3
4. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
1. In the menu, click on
2. Click twice on the user module (
figure.
3. In the Scancode set
ing options:
 activates scancode set 2 for PS/2 keyboard inputs
Set 2
 activates scancode set 3 for PS/2 keyboard inputs
Set 3
4. Click on Save
5. Turn the KVM extender off and back on again.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
47 · G&D VisionXS-C-DP-UHR
(default) to open the on-screen display.
Console setup and press
press to select one of the following options:
F8
KVM extender
field of the Configuration
.
Enter .
.
CON-Trans 1 or CON-Trans 2
section, select one of the follow-
) you want to con-