Ottobock 3R106-Pro Gebrauchsanweisung Seite 26

► Slide the tube all the way to the stop in the intended prosthetic component when mounting.
CAUTION
Improper assembly of the screw connections
Risk of injury due to breakage or loosening of the screw connections
► Clean the threads before every installation.
Apply the specified torque values.
►
► Follow the instructions regarding the length of the screws and about how to secure the
screws.
Installation on the Prosthetic Knee Joint
Required tools and materials:
>
710D4 Torque Wrench, degreasing cleaner (verify material compatibility)
1) Loosen the cap screw by approx. 2 turns (see fig. 11).
2) Clean the contact surfaces of the prosthetic knee joint and tube adapter using a degreasing
cleaning agent.
3) Slightly rotate the tube as you insert it into the prosthetic knee joint to the stop (see fig. 10).
4) Using the torque wrench, tighten the cap screw (10 Nm) (see fig. 11).
Installation on the Prosthetic Foot
Required tools and materials:
>
710D4 Torque Wrench, 636K13 Loctite®
1) Position the pyramid receiver of the tube adapter on the pyramid adapter of the prosthetic
foot.
2) For final assembly:
Use Loctite® to secure the set screws of the pyramid receiver.
3) Screw in the set screws.
4) Use the torque wrench to tighten the set screws (10 Nm).
5) Replace any set screws that are protruding or recessed too much with suitable ones (see
selection table).
6) For final assembly:
Use the torque wrench to retighten the set screws (15 Nm).
Reference number
506G3=M8X12-V
506G3=M8X14
506G3=M8X16
5.3.3 Fabricating the Prosthetic Socket
INFORMATION
The instructions for fabricating the prosthetic socket are intended only for the 3R106-Pro=KD
Prosthetic Knee Joint.
5.3.3.1 Fabricating the Test Socket
Laminating the Prosthetic Socket
Required materials:
>
640Z5* Plaster Insulating Cream, 623T3* Perlon Stockinette, 616G13* Woven Fibreglass
Stockinette, 616G12* Carbon Fibre Cloth, 617H19* Orthocryl Lamination Resin, 617H17*
Orthocryl soft, 4G70 Lamination Anchor
1) Apply plaster insulating cream to the plaster positive.
26 | Ottobock
Selection table for set screws
Length (mm)
12
14
16