Adjustments; Adjusting The Infeed Belt; Adjusting The Photocells; Adjusting The Film Raiser Bar - Minipack-Torre Pratika 56 Anweisungen Zur Bedienung Und Wartung

Chapter 5. Machine adjustment and setting up EN

5.5. Adjustments

5.5.1. Adjusting the infeed belt

Adjust the position of the infeed belt (N1) according to
the width (L) of the product to be packaged.
Loosen the knob (M1)and adjust the position of the belt
so that the product has a minimum amount of play
between the guiding rod (approx 20mm) and the rear
frame of the belt (approx 10mm).

5.5.2. Adjusting the photocells

The machine is set up for the positioning of the vertical
reading photocell (B5) recommended for extra low
products and the horizontal photocell (B6) recommended
for extra narrow products.
It is also possible to modify the distance between
photocell and the sealing bar in order to optimise the way
the products are inserted.

5.5.3. Adjusting the film raiser bar

The bar (A) is used to raise the film correctly while the
product is being inserted.
Loosen the knob (M2) and move the bar to the left when
packaging short products.
Move the bar to the right when packaging tall products.
55