Initial Use; Initial Commissioning; Switching The Appliance On - Salvis Master VisionPRO Betriebsanleitung

2.

Initial use

2.1

Initial commissioning

Deflector
. Before using for the first time, or after not using for some time: heat up the oven for ap­
proximately one hour to 100°C - turn both rotary switches to 100°C - to dry it out and dispel
odours.
Preparing a baking tray (uncoated)
Uncoated baking trays must be prepared before they are first used.
. Heat the oven to 250°C.
. Take the baking tray and
− scrub thoroughly with a grease‐dissolving detergent,
− rub thoroughly dry with a lint‐free cloth.
. Wipe a thin layer of cooking fat on both sides of the baking tray to prevent the formation of
rust.
. Place the baking tray in the heated oven with the baking side facing downwards so that the
excess fat can run off.
. Allow the cooking fat to burn into the baking tray for about 15 minutes.
2.2

Switching the appliance on

Wire rack
Ring bolt
Indicator light
Top heat rotary
switch
Indicator light
Bottom heat rotary
switch
. Remove the ring bolt from the wire rack.
. Remove the protective film.
. Before using for the first time, clean with a
grease‐dissolving cleaning product, the
− baking trays,
− wire racks,
− cooking compartment and cabinet.
D For cleaning, see page 18 section 5.
. To heat up the oven, turn both rotary
switches to the desired temperature , e.g.
− Top heat 200°C (top rotary switch),
− Bottom heat 220°C (bottom rotary
switch).
D The indicator lamp or the illuminated ring will
light up.
D The temperature is thermostatically regu­
lated.
en
15