Troubleshooting; Technical Specifications - Salvis Master VisionPRO Betriebsanleitung

en
6.

Troubleshooting

If faults should occur on this appliance, check them using the following table:
Fault
The green in­
dicator light or the
ring does not light
up when the ap­
pliance is
switched on.
The appliance is
switched on but
does not heat up.
If you cannot resolve the fault,
− turn off the appliance and disconnect from the mains power,
− do not open the housing,
− contact customer service.
7.

Technical specifications

Technical specifications
Item no.
Temperature settings for top heat and
bottom heat
Total connected load
Voltage
Fuses
Appliance noise level
We reserve the right to make technical changes
20
Possible cause
Main switch on front of the appli­
ance is not turned on.
There is no power supply at all.
The circuit breaker has tripped.
An upstream energy optimising
unit is not switching on the heat­
ing.
GN 2/1 convection oven
VP617444, VP617443
976830, 976849
variable up to 300°C
5.4 kW
400 V 3N 50/60 Hz
3 x 16 A
less than 70 dB (A)
Remedy
Turn on the main switch.
Inform the power supply company.
Have possible appliance faults checked
by an authorized customer service agent.
Reset the circuit breaker.
Check the energy optimising unit.