Ds3 Display And Rc3 Remote - Trek Ride+ Benutzerhandbuch

Q
uick start

1.2 DS3 Display and RC3 Remote

• Switching system On/Off
Briefly press the button of the Remote to switch On the system. When switched On,
the bike is in cycle mode (zero assist). To switch the system Off, press the button for
4 seconds.
• Assistance/Regeneration Level
Press the '+' button once for assistance level 1, again for higher levels.
Press the '-' button to go to a lower level. Regeneration levels can be controlled in a
similar way. Press the '-' button once for regeneration level 1, again for a higher level.
Press the '+' button to reduce regeneration.
WARNING.
It is strongly advised to ride away in a straight line when an assistance level is selected. Never select
assistance level 3 or 4 during maneuvering or riding away in a sharp corner. The powerful reaction of
motor might cause the bike to surge forward into a the sharp turn resulting in loss balance.
• Switching lights On/Off
Briefly press the light switch on the Remote to switch On the lights.
Briefly press again to switch the lights Off.
• See time, average speed, odometer, trip distance
Use one of the button to toggle between bike computer functions (Order of appearance:
Odometer, Trip distance, Trip time, Average speed, Clock, Menu screen/Setup).
To prevent loss of riding information, please make sure that the system is switched Off before the
controller is removed from the bike.
EN-6