Battery Pack Care - Trek Ride+ Benutzerhandbuch

i u
nstructions for se
NOTICE. When it is necessary to recharge, the battery pack will emit a 'beep'. Charge the battery pack immediately.
Battery packs are best charged at temperatures around 20°C, so avoid warm locations. When coming
in out of the cold, allow the battery pack to get up to room temperature (about 20°C) before charging.
• Charge status indication
On battery packs with a round charging port with translucent ring, it is possible to check the charge status
manually by touching the charge connector ring to activate the charge LED. It will light up in the color
corresponding to the charge level: Green for 100-85%, Orange for 85-25% and Red when below 25%.
• Power supply 100-240V
The power supply will adjust automatically to the local voltage.
• Charging
Connect the connector of the power supply to the battery pack.
Connect the power supply to an appropriate power source.
WARNING. Replace a damaged power cable immediately to prevent an electric shock.
The light at the charging port of the battery pack will turn red. It will turn yellow as soon as charging
starts. As soon as the yellow light on the battery charging port turns green, the battery pack is fully
charged. Disconnect both the connector from the battery pack and the power source.
Charging a fully discharged battery pack usually takes about three to six hours (depending of its
maximum capacity). After one hour of charging, the battery pack will already be charged up to
80% of its capacity.
The battery packs with the round charging connector can be left connected to the power indefinitely.
The power supply electronics will take care of the correct charging procedure. However, you will save
energy by disconnecting the power supply when the light in the charging port has turned green.
NOTICE. Since the computer inside the battery pack saves the system mileage and settings,
we discourage the use of a second battery pack. A second power supply would be a better solution.

3.10 Battery pack care

• Cleaning of the battery pack
Clean the battery pack with a damp cloth. The battery pack is splash proof, but not waterproof.
Do not immerse the battery pack in water and do not clean the battery pack with a high-pressure washer.
• Handling of the battery pack
Handle the battery pack with care to avoid damage. Do not drop or impact the battery pack,
immerse it in water, or clean it with a high-pressure washer. Do not open the battery pack (there
are no user-serviceable parts inside). Do not short-circuit the terminals.
EN-18