Setup Of The Ds3 Display/Rc3 Remote (Programming) - Trek Ride+ Benutzerhandbuch

i u
nstructions for se
• Regeneration
When the bicycle regenerates electricity for the battery, the system is in generation mode. There are
four levels of regeneration. The level of regeneration is shown by the number of red arrows stacked in
a counter clockwise direction on the Display. To increase the regeneration level, press button '-'. For
regenerative level 1 press once. Press again to increase the regeneration level to a higher level.
For a lower regeneration level press button '+'. To switch from any level of Assistance to the first
regenerative level, press and hold the '-' button. To switch from any level of regeneration to the first
assist level, press and hold the '+' button.
• Switching lights On/Off
Briefly press the light switch on the Remote to switch On the lights.
Briefly press again to switch the lights Off.
• Throttle engagement
Press the throttle lever to active the Walk-assist function. This functions operates from
a minimum of 3 km/h.
Note. The throttle function control is variable based on the lever position.
• Toggle Cycle computer Functions
Briefly press left and right toggle to display Odometer, Trip distance, Trip time,
Average speed, Clock and Menu screen / Setup. To reset Trip distance, Trip time
and Average speed, press and hold the left toggle (Select) for 3 seconds.
• Toggle Display Screen Type
Hold left or right toggle (Scroll) for 3 seconds to alternate display between Simple,
Enhanced, or Technical screens. The default screen at startup can be altered in the Setting menu.
Simple screen - Left toggle (4 sec) - Enhanced screen - Left toggle (4 sec) - Technical screen

3.5 Setup of the DS3 Display/RC3 Remote (Programming)

Scroll through the cycle computer functions with the left or right toggle
buttons (11/15) until the display shows "Settings/Setup".
Press and hold the left toggle button (11) for 2 seconds to enter the Menu
screen.
Navigate through the Menus / Values with the + or - buttons (10/12) and
confirm the selection with the left toggle (Select, 11) button. Move back a
menu with the right toggle (Scroll, 15) button. Press and hold the right toggle
(Scroll, 15) button to return to the dash screen.
In the Menu it is possible to adjust the Language (English, Français, Deutsch, Español, Nederlands)
Brightness (screen and LED), Units (Imperial, Metric), Start screen (Simple, Enhanced, Technical),
EN-14