Quick Start; Ride+ Pro Controller - Trek Ride+ Benutzerhandbuch

Q
uick start

1.1 RIDE+ Pro controller

• Switching system On/Off
Press any of the two upper buttons briefly to switch the system
'On'. Press the
When switched On, the bike is in cycle mode (zero assist).
• Assistance/Regeneration Level
Press the '+' button once for assistance level 1, again for
higher levels. Press the '-' button to go to a lower level.
Regeneration levels can be controlled in a similar way.
Press the '-' button once for regeneration level 1, again for
a higher level. Press the '+' button to reduce regeneration.
WARNING. It is strongly advised to ride away in a straight line when an assistance level is selected.
Never select assistance level 3 or 4 during maneuvering or riding away in a sharp corner. The powerful
reaction of motor might cause the bike to surge forward into a the sharp turn resulting in loss balance.
• Switching lights On/Off
Press the button for 2 seconds to switch On/Off the
controller display light, and, if present, the front and rear
lights. Once activated, the text 'Light On' or 'Light Off' will
appear in the lower field of the display.
• See time, average speed, odometer, trip distance
Use button to change bike computer functions (Order of
appearance: trip distance, odometer, average speed, time).
To prevent loss of riding information, please make sure that
the system is switched Off before the controller is removed
from the bike.
EN-5

1. Quick start

This manual has all the information that you'll need to get the
best from your electric bicycle. We strongly recommend that
you read it through.
However, for quick use of the bike, please read the Quick Start
guide for the type of controller and battery pack on your bicycle.
button to switch the system Off.