Trek RIDE+ Benutzerhandbuch Seite 14

i
nstructions for
WARNING. It is strongly advised to ride away in a straight line when an assistance level is selected.
Never select assistance level 3 or 4 during maneuvering or riding away in a sharp corner. The powerful
reaction of motor might cause the bike to surge forward into a the sharp turn resulting in loss balance.
To increase assistance, press button '+'. For assistance level 1, press once. Press again for more
assistance. For less assistance press button '-'. When there is no assistance level shown, there is
no assistance so riding is the same as pedaling a normal bicycle.
• Regeneration
When the bicycle regenerates electricity for the battery, the system is in generation mode.
There are four levels of regeneration. The level of regeneration is shown by the arrows at the bottom
of the screen. To increase the regeneration level, press button '-'. For regenerative level 1 press once.
Press again to increase the regeneration level to a higher level. For a lower regeneration level press
button '+'.
To switch from any level of Assistance to the first regenerative level, press and hold the '-' button.
To switch from any level of regeneration to the first assist level, press and hold the '+' button.
The 'G' and the arrow will appear on the display during generation of energy.
• Distance, Odometer, Chronometer, Average speed, Clock
The right bottom corner of the screen shows the distance,
odometer, chronometer, and average speed (Order of
appearance: trip distance, odometer, average speed, time of
day). Press the
chronometer, or average speed, keep this button pressed for
2 seconds.
• Switching lights On/Off
Press the , button for 2 seconds to switch On/Off the Controller display light, and, if present, the
front and rear lights.
EN-11
u
se
button to switch modes. To reset distance,
1
3
1
3
2
4
2
4