Herunterladen Inhalt Inhalt Diese Seite drucken

Trike Ohne Federung - HASE Bikes KETTWIESEL Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für KETTWIESEL:
Inhaltsverzeichnis

Werbung

KETTWIESEL / LEPUS

Trike ohne Federung

Laufräder demontieren
Halten Sie das Rad fest
Drehen Sie die M Schraube mit einem Innensechskant
schlüssel mm gegen den Uhrzeigersinn heraus
Nehmen Sie das Laufrad ab Halten Sie dabei die Bremsscheibe
fest damit sie nicht herunterfällt
Laufräder montieren
Schieben Sie die Bremsscheibe
von unten zwischen die
Bremszangen und halten Sie sie an die Antriebsschraube
Halten Sie die Nabe des Laufrades
auf die Bremsscheibe
so dass die Stifte der Nabe durch die Bohrungen der
Bremsscheibe hindurchgehen und in die Bohrungen der An
triebsschraube hineinragen
Schrauben Sie das Laufrad mit der QS Adapterscheibe der
Nordlock Sicherungsscheibe und der M Schraube mit
einem Innensechskantschlüssel mm handfest an
Halten Sie das Rad fest und schrauben Sie die M Schraube
mit einem Drehmoment von Nm im Uhrzeigersinn fest
Achtung!
Die M Schrauben für die Nabenbefestigung müssen
unbedingt mit Nm angezogen werden Bei geringerem
Anzugsdrehmoment kann die Welle brechen und der Antrieb
ausfallen
28
KETTWIESEL / LEPUS 04/17
3
2
4
Anhang für Fachhändler
Trike without suspension
Removing the wheels
Brace the wheel
Unscrew the M allen bolt by turning it counterclockwise
using a mm Allen key
Hold the brake disc
and remove the wheel
1
Installing the wheels
Slide the brake disc
between the two brake calipers from
below and hold it against the head of the drive screw
aligning the holes
Hold the hub of the left wheel
that the hub pins protrude through the holes of the brake disc
and into the holes in the head of the drive screw
Screw the wheel onto the frame with the QS adapter shim
the Nordlock washer and the M allen bolt using a mm
Allen key tightening lightly at first
Brace the wheel and tighten the M allen bolt with a torque
of Nm ft lbs
Attention!
The M allen bolt must be tightened with a torque of Nm
ft lbs If the bolt is tightened with less torque the shaft
could brake and the drive could fall out
/ Appendix for dealers
against the brake disc
so
www.hasebikes.com

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Lepus

Inhaltsverzeichnis