Technical Details; Replacement Parts And Wearing Parts - Beurer EM 80 Gebrauchsanweisung

(3) Check that the electrodes are positioned properly and make sure that the
adhesive electrodes are not overlapping.
(4) Increase pulse intensity in stages.
(5) The batteries are almost empty. Replace these.
You are aware that the electrodes feel uncomfortable. What should I do?
(1) The electrodes are badly positioned. Check positioning and if necessary
reposition the electrodes.
(2) The electrodes are worn. Due to the fact that current distribution can no
longer be guaranteed evenly over the entire surface, these may lead to
skin irritation. You must therefore replace these.
The skin in the treatment area becomes red. What should I do?
Stop treatment immediately and wait until the skin has returned to normal. If
any redness beneath the electrode soon disappears, this is not dangerous
and is due to the increased circulation which has been stimulated locally.
If, however, the skin irritation remains and there is possibly itching or inflam-
mation, please consult your doctor before further use. It may possibly be
caused by an allergy to the adhesive surface.

11. Technical details

Name and model: EM80
Initial curve shape: biphase square-wave pulse
Pulse duration: 40-250 μs
Pulse frequency: 1-120 Hz
Output voltage: max. 90 Vpp (at 500 Ohm)
Output current: max. 180 mApp (at 500 Ohm)
Power supply: 3x AA batteries
Treatment time: adjustable from 5 to 90 minutes
Intensity: adjustable from 0 to 15
Operating conditions: 10°C-40°C (50°F-104°F) with a relative humidity
of 30-85%
Storage conditions: -10°C-50°C (14°F-122°F) with a relative humidity
of 10-95%
Dimensions: 170 x 125 x 48 mm
Weight: 235 g (without batteries) , 310 g (incl. batteries)
Explanation of symbols: Application part type BF
Caution! Read the instructions for Use.
Note: If the device is not used according to these specifications, perfect
functioning is not guaranteed.
We reserve the right to make any technical alterations that are necessary in
order to improve and develop the product further.
This unit is in line with European Standards EN60601-1, EN60601-1-2 and
EN60601-2-10 and is subject to particular precautions with regard to elec-
tromagnetic compatibility (EMC). Please note that portable and mobile HF
communication systems may interfere with this unit. For more details, please
contact customer service at the address indicated.
The device meets the requirements of the European Medical Products Direc-
tive 93/42/EC and the German Medical Products Act. In accordance with the
Operators' Ordinance on Medical Products, regular measurement precision
controls must be carried out if the device is used for commercial or economic
purposes. Even in the case of private use, we recommend checking measure-
ment precision at two-yearly intervals at the manufacturers.

12. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding
listed service address under the stated material number.
Designation
8x adhesive electrodes (45
x 45 mm)
4x adhesive electrodes (50 x
100 mm)
30
The device can emit effective output values
above 10 mA, averaged over every five second
interval.
Item number and/or order number
661.02
661.01