Disposal; Technical Specifications; Warranty / Service - Beurer HK 72 Akku Gebrauchsanweisung

Problem
The blue LED display for the temperature
settings (6) does not light up when:
– the fully charged battery pack is con-
nected to the heating pad and
– the button for controlling ON/OFF and
temperature settings has been pressed.
The green LED display for the state of
charge lights up or flashes when the bat-
tery pack is not connected to the heating
pad.

10. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the device
in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have
any questions, please contact the local authorities responsible for waste disposal.

11. Technical specifications

See the type plate label on the heating pad, on the battery pack and on the charger.
Operating temperature:
Storage temperature:
Recommended storage temperature:
Subject to technical changes

12. Warranty / Service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides a
warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which ensue
from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 3 years, commencing from the purchase of the new, unused product from
the seller.
The warranty only applies to products purchased by the buyer as a consumer and used exclusively for per-
sonal purposes in the context of domestic use.
German law shall apply.
During the warranty period, should this product prove to be incomplete or defective in functionality in accor-
dance with the following provisions, Beurer shall carry out a repair or a replacement delivery free of charge,
in accordance with these warranty conditions.
If the buyer wishes to make a warranty claim, they should approach their local retailer in the first
instance: see the attached "International Service" list of service addresses.
The buyer will then receive further information about the processing of the warranty claim, e.g. where they
can send the product and what documentation is required.
All manuals and user guides at all-guides.com
Cause
The heating pad or the battery
pack is faulty.
Display for the state of charge of
the battery pack:
LED lights up for approx. 3 se-
conds: state of charge > 25%
LED flashes 3x: state of charge
< 25%
0 to +45°C
-10°C to +45°C
-10°C to +25°C
19
Solution
Send the heating pad and
the battery pack to Service.