Changes To The Settings; Doctor's Function; Cleaning And Storage - Beurer EM 80 Gebrauchsanweisung

Note: Setting OFF time to '00' ensures that there is no
period of relaxation between the individual cycles.
• Hold ENTER depressed for approx. 2 seconds to advance to
the treatment time.
Using the UP/DOWN keys, select the desired treatment time
and confirm with ENTER (Fig. 7, Example of 30-minute treat-
ment duration).
• The device is in wait status (Fig. 8).
• Press ON/OFF to start stimulation treatment. Operation
status starts to change and pulse frequence is displayed
alternately with pulse width (Fig. 9).
• Select the pulse intensity which is the most comfortable for
you by pressing keys CH1 ± , CH2 ± , CH3 ± , CH4 ± .
The pulse intensity display adapts accordingly
Note: Your individualised programme settings are stored and automati-
cally retrieved when you select it next.

7.4 Changes to the settings

Changing intensity (during application)
• CH1±, CH2±, CH3±, CH4±: Changing the intensity for each channel.
• DOWN key ▼ : the intensity of all channels is reduced.
Interrupting stimulation
Press the ON/OFF button.
If you press it again, the application is resumed.
Switching off a complete channel
Press the CH- key until the channel reaches the lowest intensity, then hold
the key depressed until the channel no longer appears in the display.
Hold down the corresponding key CH+ to reactivate the channel.
Changing application (completely or single parameters)
• ON/OFF: to interrupt stimulation
• MENU: back to program selection window or main menu
• Set required parameters. Confirm with ENTER. Press ON/OFF to continue
application.

7.5 Doctor's Function

Doctor's Function is a specific setting to allow you to call up your specific
personal programme even more easily.
Fig. 7
Your individual programme setting is immediately retrieved in wait status
when you switch on and is activated by simply pressing the ON/OFF key.
Settings for this individual programme may, for example, be on the advice of
your doctor.
Fig. 8
With the Doctor's Function, only pulse intensity can be changed during
stimulation treatment. All other parameters and programmes of the Digital
TENS/EMS are blocked in this case and cannot be modified or called up.
Setting the Doctor's Function:
Fig. 9
• Select your programme and appropriate settings as described under 7.2
or 7.3.
• Before you activate the programme by pressing the ON/OFF key, hold
ON/OFF and
Storage in Doctor's Function is confirmed by a long signal tone.
Cancelling Doctor's Function:
To clear the device again and access other programmes, hold down the two
keys ON/OFF and
during stimulation). Cancelling of the Doctor's Function is confirmed by a
long signal tone.

8. Cleaning and storage

Adhesive electrodes:
• In order to ensure that the electrodes adhere for as long as possible, they
should be cleaned carefully with a damp, lint-free cloth.
• After use, stick the electrodes onto the backing film.
Cleaning the unit:
• Remove the batteries from the device every time you clean.
• Clean the unit after use with a soft, slightly moistened cloth. In case of
more extreme soiling you can also moisten the cloth with mild soapy water.
• Ensure that no water penetrates into the device. If this should ever happen,
only use the device again once it is completely dry.
• Do not use any chemical cleaners or abrasive agents for cleaning.
28
keys down simultaneously for approximately 5 seconds.
once again for approximately 5 seconds (not possible