Setting The Water Temperature - Beurer FB 65 Gebrauchsanweisung

At the end of use
To switch the foot bath off again before the automatic switch-off takes effect (see "Timer function"), press
the ON/OFF button
Switch the foot bath off after use and remove the mains plug from the socket.
Pedicure attachments
The foot bath has a motorised pedicure centre
There are three different attachments
• The portable pedicure device attachment
• The brush attachment
• The massage attachment
We recommend attaching the pedicure attachments when the foot bath is in standby mode.

Setting the water temperature

You can use the foot bath with and without water heating. The water heating can be set to between
34°C and 48°C. The water heating starts at 34°C. You can increase/decrease the water temperature in
2°C increments.
1. To switch the water heating on, press the "Increase water temperature" / "Switch on water heating" func-
tion button .
13
2. To increase the water temperature in the foot bath, press the "Increase water temperature" / "Switch on
water heating" function button
3. Select your desired water temperature using the "Water temperature / Water heating" function buttons
. The desired water temperature is shown briefly on the display
14
ing the current water temperature.
4. The heating process starts.
• The foot bath has a memory function that remembers the set water temperature until the
power circuit is interrupted.
• For quicker heating, we recommend activating the "Bubble" function as well.
• Different water temperatures have a positive effect on the feeling in your body. Choose the
right water temperature for your wellness experience:
- Cold water (24–29°C – without water heating) has a refreshing and vitalising effect on
the body. It awakens your spirits and brings new energy.
- Lukewarm water (30–40°C) supports an optimal wellness experience and has a nurtur-
ing and constructive effect.
- Warm water (approx. 42–48°C) has a particularly soothing and warming effect on the
body and, as a result, can support the immune system. Please note that the water tem-
perature should increase slowly and should not be set too high initially.
5. To reduce the water temperature in the foot bath, press the "Decrease water temperature" / "Switch off
water heating" function button
6. The water heating has been switched off when the LEDs of the "Water temperature / water heating" func-
tion buttons
13 14
Vibration massage
You can switch a vibration massage on during use.
1. To switch the vibration massage on, press the "Vibration" function button
starts to light up.
15
2. To switch the vibration massage off again, press function button
again. The ON/OFF button
12
9 10 11
can be used to stimulate the reflex zones in the soles of your feet.
10
provides a pleasant massage for your feet and stimulates circulation.
11
.
13
.
14
turn off.
flashes again. The foot bath is in standby mode.
12
for individual pedicure.
8
that you can attach to the motorised pedicure centre
can be used to remove dead skin cells and calluses.
9
17
before the display returns to show-
19
. The LED of function button
15
again. The LED turns off.
15
:
8
13