Casio fx-CG50 AU Bedienungsanleitung Seite 606

7. After configuring the required settings, press 6(SAVE) or w.
• This displays the dialog box shown below.
8. Input the custom probe registration number (1 to 99) and then press w.
• This registers the custom probe and returns to the custom probe list screen.
k
Assigning a Custom Probe to a Channel
1. On the sampling screen, use f and c to select the channel to which you want to
assign the custom probe.
2. Press 1(SENSOR) to display the sensor selection screen.
3. Press 4(CUSTOM).
• This displays the custom probe list screen.
4. Use f and c to select the custom probe you want to assign and then press w.
k
Changing the Settings of a Custom Probe
1. On the custom probe list screen, use f and c to select the custom probe whose
settings you want to change.
2. Press 2(EDIT).
• This displays a custom probe setup screen.
3. Perform steps 3 through 6 under "Registering a Custom Probe".
4. After configuring the required settings, press 6(SAVE) or w.
• This returns to the custom probe list screen.
k
Recalling CMA or Vernier Sensor Settings to Register a Custom Probe
1. On the custom probe list screen, press 4(CMA) or 5(VERNIER).
• This displays a sensor list.
2. Use the f and c cursor keys to move the highlighting to the sensor whose settings you
want to use as the basis of the custom probe and then press w.
• The name of the selected sensor and its setting information are shown on the custom
probe setup screen.
3. Perform steps 3 through 8 under "Registering a Custom Probe". However, you will not be
able to change the sensor type.
ε
-24
Using a Custom Probe