Casio fx-CG50 AU Bedienungsanleitung Seite 594

5. Configuring the Sampling Setup
You can configure detailed settings to control individual sampling parameters and to
configure the Data Logger for a specific application. Use the Sampling Config screen to
configure settings.
There are two configuration methods, described below.
Method 1 ... With this method, you configure settings for the sampling interval (Interval)
and number of samples (Samples).
Method 2 ... With this method, you configure settings for the number of samples per
second (Sample/sec) and the total sampling time (Total Time).
You can also use the Sampling Config screen to configure trigger settings. See "Trigger
ε
Setup" (page -15).
Initial default settings are shown below.
• Setting Method: Method 1
• Interval: 0.2 sec
• Samples: 101
• Sample/sec: 5 (This setting is not displayed in the case of Method 1.)
• Total Time: 20 sec
• Warm-up: Auto
In the case of "Manual Sampling", a special Manual Sampling Config screen will appear. For
more information, refer to "Configuring Manual Sampling Settings" (page -19).
k
Using Method 1 to Configure Settings
1. On the sampling screen, press 2(CONFIG).
• This displays the Sampling Config screen with "Interval" highlighted.
2. Press 1(sec) or 2(min) to specify the sampling interval unit.
3. Press e.
• This displays a dialog box for configuring the sampling interval setting.
4. Input the sampling interval and then press w.
ε
-12
Configuring the Sampling Setup